![]() Windows (will try using my Macbook Pro too but I doubt it would make a difference), cannot be configure to 2.2, or I just don't know how. AVM70 has 2 independent subwoofer outputs, both subwoofers are connected for normal use. Output is via HDMI from my MacBookPro laptop, to the AVM70's HDMI input. Since I don't have any multichannel DAC and am using the PC standalone version, my only option is to use my existing AVP, the 15.1 AVM70. I am using the PC standalone DLBC beta version. Let me try in point form to make things clearer, but with such a lengthy post, you may actually find it more difficult to understand. Sorry, I thought I was clear about using a single subwoofer as part of my experiment in using DLBC. ![]() I have not tried to limit the EQ range but as it is now I feel the sound more transparent, like comparing two different pairs of speakers. With DL on, it sounds better, to me anyway but the bass does sound a little thinner, and that must be because of the much tamed mid bass. That's okay because this it only for beta testing, if it works well I will buy a multichannel DAC and it should then works fine with 2.1 or 2.2. ![]() Too bad between windows, the AVM70, and DLBC, it just seems impossible to map for 2.2. So next time I am going to turn one subwoofer off manually, will have to find out which sub works better. With XT32, at least the two subs were time aligned. I think the suck out is so bad because now the two SVS subs are cancelling each other's big time, because there are no time/phase alignment between the two. And obviously I set Anthem Room Correction for that input to off.ĭid another run, tighly focussed 7 positions this time, DLBC couldn't do a better job than Audyssey, but still better than AARCG on the deep bass at least. So I got my Mcbook pro connected via HDMI to an input on may AVM70 and configured that input for 2.2, left, right, sub1 and sub2, for now. I am trying the Beta on my HT setup for now as you know I don't have a multi-channel DAC yet. So I thought I would try my luck here, may be you, or Flak can help me solve this puzze. ![]() It usually took a day to several day for them to respond anyway so by the time they understood my question and suggest solution, it could take a long time. I created a ticket at the helpdesk but unless happens to be the oner handling the ticket, I am not sure if they could help me quickly enough. I double checked my windows configuration and didn't see anything unusual. Subwoofer Output 4 appeared to response as expected. When I proceed to the next step, that is to "calibrate", something strange happened, after the sweeps, left, right worked as expected but subwoofer output 3 appeared to be exactly the same as left output 1. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |